Quickstart

1) Install & attach

Install the robot/preset package via the cTrader interface (or cTrader Store), then attach the robot to a chart.

2) Select a preset profile

Choose a preset that matches your symbol, timeframe, and risk profile. Presets are designed to be explicit and versionable.

• Examples: CORE_EURUSD_M15, CORE_XAUUSD_M5, CORE_NAS100_M15
• If the preset name does not match your chart symbol/timeframe, switch the chart or select the correct preset.

3) First-run checklist (most important)

Before you expect any action, verify these items. Most “it doesn’t trade” issues are caused here.

4) Safe defaults

If you are unsure, start with conservative settings. You can always increase risk later — but you cannot “undo” a bad first configuration.

• Use a small base risk (e.g., 0.25%–0.50% per trade) for validation runs.
• Avoid running multiple bots on the same symbol until you understand interactions.
• Disable during high-impact news if your broker spreads widen significantly.
• Prefer stable sessions (avoid low-liquidity hours on FX; watch rollover conditions).

5) Verify behavior (before you trust it)

Your goal is not “profit” on day one — it’s confirming that the robot behaves as documented.

• Check the cTrader log/messages for status lines (startup, symbol checks, filter states).
• Confirm the robot sees the intended timeframe(s) and indicator values.
• Confirm that order volume is valid for your broker (min/max/step).
• Let it run long enough to encounter at least one full signal cycle.

6) If something looks wrong

Use this order. It is fast and avoids unnecessary back-and-forth.

1. Re-check the First-run checklist (symbol, timeframe, session, spread, permissions).
2. Open Troubleshooting (next page): common error patterns and fixes.
3. If it’s platform/broker specific (symbol mapping, permissions), consult official cTrader support channels.